I vaguely remember setting a screen width during setup.  I've searched the help files and cannot find a reference on how to reset that to a smaller size.  It appears i set it too wide and it will bump the details screen under my left panes (projects, etc) instead of nicely next to it.  It only does this when on my 768x1024 monitor.  If I reposition it to my widescreen laptop display it works fine.

I've gone to my users settings and tried setting it smaller there but it won't let me go under the 990px width I set at install.  How can I fix this?

TIA 

---

Keith Barrows
Owner
Barrows Software Solutions, LLC
http://sol3.net

The minimum width is 1100px, so I'm not sure how you were able to save it at 990px.  Did you perhaps have it on dynamic width?

---

Dan Suceava
http://www.axosoft.com

To be honest I don't know what I did during setup.  I have *my* settings set to dynamic.  It will, about 20% of the time, size just slightly larger than the space available and display below the left panels.  If I can get some screenshots I will try to upload them.

---

Keith Barrows
Owner
Barrows Software Solutions, LLC
http://sol3.net

Don't see a way to add attachments so I'll post a link instead.  http://sol3.net/photos/starpilot/picture13867.aspx. 

I ended up deleting  my settingsXml in the users table because of another error.  When I next logged in it rebuilt my settingsXml and put me back in a 1100px wide screen.  I then went to users options and set it to dynamic.  It seems to do this more often when I am on a 1024px wide screen.  When I move it to the 1600px wide screen it behaves correctly 99% of the time.

---

Keith Barrows
Owner
Barrows Software Solutions, LLC
http://sol3.net